Directions:
Step 1: Push buckle through elastic opening on the bottom back pad of the Baby Buckle Pad®. (The first time this may be a snug fit to pop on but it will fit buckles with a 'triangle' width as shown in car seat photo below.) The animal face will be looking up at the child. Please note that the animal face will be upside down for the parent as seen in the final step (4) below.
Step 2: Buckle should rest on grip material on inner bottom pad. See photo below.
Step 3: Buckle your child securely into the harness seat as shown in photo below. Pull top Baby Buckle Pad® between harness straps if necessary.
Step 4: Fold over the top pad between harnesses' straps to meet the Velcro tabs on the bottom of pad. The animal face will be looking up at the child. Please note that the animal face will be upside down for the parent.
To Remove:
* Lift top pad of Baby Buckle Pad® from bottom of Baby Buckle Pad® velcro & release buckle to remove child. Reverse steps 1 -4.
* Okay to leave Baby Buckle Pad® attached for next use. Always re-adjust Baby Buckle Pad® if leaving it on the seat buckle. It's the same idea as you would normally adjust harness straps every time you position your child in seat.
* Hand Wash Recommended Only.
WARNING: This is NOT a toy. Use adult supervision at all times.
